MultiMaker Treat Maker Guide: Donuts, Cupcakes & Waffles

Quick answer

The Dash MultiMaker Treat Maker System lets you make mini donuts, mini cupcakes, and a heart waffle using one base and interchangeable plates. Follow the steps below for each treat type, including plate swapping, batter tips, and doneness checks.

Step-by-step instructions for each treat

1. 1. Preheat with the correct plate installed: Snap your chosen plate (donut, cupcake, or waffle) onto the base and plug it in. Wait about 3–4 minutes until the indicator light turns green. Common mistake: starting with a cold plate leads to uneven cooking and batter sticking.
2. 2. Fill the cavities without overfilling: Use a small spoon or a piping bag to fill each cavity about ¾ full. For donuts, fill each ring to just below the center post — too much batter will puff over the middle hole. For cupcakes, a heaping teaspoon per well is enough. For the heart waffle, pour batter to cover the bottom grid, then close the lid. Check that the donut centers stay open; if they close up, use less batter next time.
3. 3. Cook until the steam thins: Close the lid and let the treats cook. Mini donuts take about 4–5 minutes, mini cupcakes about 5–6 minutes, and the heart waffle about 5–7 minutes. Watch for steam: when it visibly thins and almost stops, the treat is done. Common mistake: opening the lid too early can split the treat or cause the batter to stick.
4. 4. Remove treats gently with a silicone tool: Use a silicone spatula or tongs to lift each treat out. Metal utensils will scratch the nonstick coating. For donuts, gently pry around the outer ring first, then the center post. For cupcakes, a small twist helps release them. For the waffle, lift one edge and peel it back. If a treat sticks, let it cook 30–60 seconds longer — undercooking is the usual cause.
5. 5. Swap plates for the next treat type: Unplug the base and let it cool for 5 minutes. Press the plate release button (located on the side) and lift the plate off. Snap the new plate in until it clicks. Plug back in and preheat again. Common mistake: trying to swap plates while the base is hot can cause burns or warping. Always unplug before changing plates, even if the base feels cool.
6. 6. Decorate after cooling: Let treats cool on a wire rack for 5 minutes before adding frosting, glaze, or sprinkles. Warm treats will melt icing and cause toppings to slide off. For donuts, dip the top in glaze and let excess drip off. For cupcakes, pipe frosting once completely cool. For waffles, add syrup or fruit right before serving.

Product details

• MultiMaker® Treat Maker System: Mini Donut, Mini Cupcake, Heart Waffle: The MultiMaker Treat Maker System includes three removable plates: 9 mini cupcakes, 7 mini donuts, and one full-sized heart waffle. You don't need separate appliances for different treats — one base does all three, saving counter space and cleanup time.